How to apply our stickers

White, die-cut vinyl. Best for smooth, non-porous surfaces.

Works best on: helmets, visors, windows, motorcycle fairings, car bodywork.

Note: Adhesion is poor on ABS plastic and similar textured/low-energy plastics.


Application steps

  1. Clean the surface thoroughly. Remove dust, grease, wax. Dry completely.
  2. Peel the backing paper to expose the sticky (reverse) side of the vinyl on the transfer film.
  3. Align and apply in one smooth motion. Start from one edge and move across, applying even pressure.
  4. Burnish firmly with a cloth. Go over the entire sticker so every part bonds with the surface.
  5. Wait a few minutes. Let the adhesive set.
  6. Remove the transfer film very slowly. Peel back on itself at a low angle. If any small vinyl lifts, lay the film back down and rub again.